燃氣發電機組的使用功率往往關系到作業的進度，因此對于這方面是要上心的，那么應該知道的是發動機組的功率會受到什么因素的影響，在此講講周圍環境的溫度因素。

　　The power used by the gas generator set is often related to the progress of the operation, so it is important to pay attention to this aspect. Then what should be known is that the power of the engine set will be affected by what factors. Here we talk about the temperature factors of the surrounding environment.

　　按照通用的技術要求，一般定義發電機的使用環境溫度為40攝氏度，所有的設計及功率都按照這一環境溫度而言。事實上，對燃氣發電機組而言，環境溫度應該為發電機的進風溫度。由于發電機是與燃氣發電機組一起工作，燃氣發電機組在使用時會發熱，再加上環境溫度又比較高，使得整個發電機組所處的整個空間內溫度超過會40攝氏度。

　　According to the international general technical requirements, the general definition of the use of the generator ambient temperature is 40 degrees Celsius, all design and power are in accordance with this ambient temperature. In fact, for a gas generator set, the ambient temperature should be the inlet temperature of the generator. Because the generator works with the gas generator set, the gas generator set will heat up during use, and the ambient temperature is relatively high, so that the temperature in the whole space where the whole generator set is located exceeds 40 degrees Celsius.

　　對環境溫度而言，若其低于40攝氏度，則發電機的功率可以比額定功率大，比如春秋冬季，雖然機組散發熱量，但環境溫度較低，所以它所處的周圍空間的溫度就不會超過40攝氏度，這時候，發電機組的輸出功率就會達到正常的額定功率。當環境溫度超過40攝氏度時，發電機組的功率會有一定的修正。

　　For the environment temperature, if it is lower than 40 degrees Celsius, the power of the generator can be larger than the rated power, such as the spring and autumn winter, although the unit send out quantity of heat, but the environment temperature is lower, so it's the temperature of the surrounding space would not be more than 40 degrees Celsius, at that time, the output power of the generator set will reach normal power rating. When the ambient temperature exceeds 40 degrees Celsius, the power of the generator set is modified to some extent.

　　當然，燃氣發電機組的輸出功率受外界很多因素的影響，除了環境溫度，還有平均海拔高度，空氣濕度以及大氣壓力等對發電機組都有很大的影響，要想順利使用就需要去多多了解這方面的知識內容才行。

　　Of course, the output power of the generator set is affected by many external factors, in addition to the environmental temperature, and the average altitude, air humidity and atmospheric pressure have a great impact on the generator set, in order to smooth use you need to know more about the content of professional knowledge in this area.

　　此外，使用發電機組啟動之前，正確的預熱方法是先將保溫被罩在水箱上，打開放水閥，向水箱內連續注入60-70℃的清潔軟水，用手觸摸放水閥流出的水有燙手感覺時，再關閉放水閥，向水箱灌入90-100℃的清潔軟水，并搖轉曲軸，使各運動件得到適當預先潤滑，然后再行啟動。

　　In addition, before starting the generator set, the correct preheating method is to cover the thermal insulation on the water tank, open the water valve, into the water tank continuous injection of 60-70 degrees of clean soft water, touch the water valve out of the hot feeling, then close the water valve, into the water tank into 90-100 degrees of clean soft water, and shake the crankshaft, The moving parts are properly lubricated in advance, and then start again.

　　燃氣發電機組功率會受到周圍溫度影響的內容我們就講解到這里了，注意事項以及禁忌事項要在使用之前進行充分的了解，規避問題的出現很重要。更多內容您可以來網站m.kan138.cn進行咨詢！

　　The power of gas generator set will be affected by the surrounding temperature. We will explain the content here. Precautions and taboos should be fully understood before use, and it is important to avoid the emergence of problems. More content you can come to the website /m.kan138.cn for consultation!